Error Codes
In the below you find error codes coming from the tool.
Robot & connection Errors |
Description |
Possible causes |
|---|---|---|
10 ERROR_ROBOT_NOT_CONNECTED_INTERFACE |
Ethernet connection to
the SpinBridge is faulty
|
* Incorrect network
setup on robot
|
11 ERROR_ROBOT_NOT_CONNECTED_MODBUS |
Serial connection between
tool & SpinBridge is faulty
|
* Cable between tool &
SpinBridge not
connected
|
12 ERROR_ROBOT_EMERGENCY_STOP |
Robot is in emergency stop
the SpinBridge is faulty
|
* Robot emergency
button is pushed.
* Safety sensor on tool
is exposed.
|
13 ERROR_ROBOT_SECURITY_STOP |
Robot security stop has
been activated
|
* Check robot
protective stop
|
14 ERROR_ROBOT_NOT_POWERED_ON |
Robot is not powered on
|
* Power up the robot
|
Tool and system Errors |
Description |
Possible causes |
|---|---|---|
50 to 79 |
Internal tool errors
|
* Reset the tool
|
80 to 100 |
Screw motor errors
|
* Reset the tool
|
82 ERROR_TOOL_MOTOR_UNDER_VOLT |
48V is missing |
|
83 ERROR_TOOL_MOTOR_OVER_TEMP |
Screw motor is too hot |
* Reduce the robot
cycle time
|
Safety shield Errors |
Description |
Possible causes |
|---|---|---|
100 to 120 |
Safety shield errors
|
* Home safety shield
or reset tool.
|